Custom Pilothouse Schooner 65' Staysail Rig

Mechanical:
-fuel comsumption 1.1 gallons per hour at 1,500 rpm
@ 6.5 kn.
- 100 HP Beta Marine Model 105 with ZF transmission
- Parker duplex fuel filters with water separation
- Balmar 12v high output alternator with MC-612 Regulator, serpentine belt drive
- Balmar 24v high output alternator with MC624 Regulator, serpentine belt drive
- Prop shaft (new 2013)
- 4 blade max prop (new 2016)
- Spare fixed bronze prop (new 2013)
- PSS stuffing box and dripless seal (new 2016)

Electrical:
- Completely professionally rewired.
- Batteries new in 2021 Mastervolt AGM type:
- 4ea. AGM slimline 200ah for 24v house bank 400ah capacity
- 2ea. AGM slimline 170ah for 12v electronics and Nav bank 340ah capacity
- 1ea. Trojan AGM start battery
- Blue Sea 360 Electrical panel with Multi function displays (2), 12v 24v and 110v systems
- LED navigation and deck lighting (new 2019-2023)
- Magnum® Invertor charger 24v
- Prosine® charger 12v
- Honda 2000e backup generator

2023 new Max prop. Plus two spares; an older Max prop, and a fixed three blade spare. All props are bronze.

مركب شراعي مزور Shipwright خشب الساريات () مع الفولاذ المقاوم للصداء يقف تزوير (2014)

Spars:
Main mast is laminated solid Douglas fir. Foremast and booms are solid mahogany. Both spars were pulled and refinished in 2021 in Penasco MX, Main mast is the old foremast from the Crowninshield schooner MARTHA and has the original MARTHA spreaders Bowsprit is original, of Vietnamese Sao wood.

Standing Rigging and Fittings:
Rigging is all new in 2014-16, with 1x19 3/8" SS wire; all Hayn terminals; swaged upper and mechanical lower fittings; new bronze turnbuckles. Main mast lowers in intermediates are 13mm Dynex Dux synthetic (this was only done as the mast was set up for wire eyes already; eyes were re-served and leathered in 2021). New SS mast bands and irons; SS gammon, kranze iron, bobstay chainplate; new bronze anchor rollers from PT foundry. Original Bronze chain plates.

Sails:
Used: Bacon and Associates fully battened Main in working condition 3 reef points; Harken track and slides and Harken outhaul track. Elvstrom Forestaysail and Main Staysail - these are serviceable for inland use.

New Sails in 2016: Elvstrom Jib, (restitched cover in Puerto Vallarta in 2021) plus new Shaefer furler in 2016. Elliot Pattison Fisherman upper sail with bag on Tides Marine strong track, new 2016; Elliot Pattison Asymmetrical spinnaker with sock, new 2016 . Fully battened Marconi foresail, new 2020 Ulman sails San Diego (never used, this was for going west and requires boom modification and track). Stock material, have enough new 10oz. cloth for complete new main and staysails on the vessel.

12 بطارية فولت, 110 جهد طاقة الشاطئ, 7 البطاريات التي يتقاضاها: محرك, خط كهرباء , مولد كهربائي

Length over all is 65 feet.

Originally built in Vietnam in the '60s for a US naval officer, this schooner underwent an incredible 10-year refit completing in 2016. This involved taking the vessel down to a bare hull and constructing a new interior, cabin structure, pilot house, decks and rig based on a design by Tad Roberts, NA.

Hull Materials: The hull is built entirely of "Sao wood" a Vietnamese hardwood, an extremely strong, dense, and rot-resistant lumber. The hull was taken back to bare wood and completely refinished in 2018. Below the waterline the hull is caulked, and the topsides were splined in 2018 to create a seamless, durable exterior. The ballast keel is cast iron; sandblasted, epoxy coated and faired in 2021 to prevent corrosion.

Rudder and steering were completely replaced in 2016. Rudder is Hydrotek marine plywood laminated over solid nickel aluminum bronze stock with 3/4" nickel aluminum bronze stay bolts in compression over G10 tubes. Rudder design was a group effort by designer Tad Roberts, Pete Langley of PT foundry and Simon Miles of 206 Composites LLC. All stock interfaces are G Flex and the entire rudder was vacuum bagged with infused layup by Simon -- he was on Team Oracle and knows his stuff. New bronze rudder stuffing box and quadrant by PT foundry.

Decks: Replaced using ¾” Sapele plywood with 5/8 Douglas fir laminated over. The covering boards are Sapele, and sills around cabin trunk are Yellow Cedar. The sill was glassed prior to installation, then wrapped with 2 layers of 10oz cloth in West Systems epoxy. These high quality materials and hardwoods will ensure durability and longevity of service.

Bulwarks: Powder coated aluminum with Sapele cap rails.

New guards, main mast step and Boom kin: purpleheart.

Cabin sole and interior: Custom milled tongue & groove Angelique teak. Interior ceiling, cabin side, cabin beams and trim are all Silverballi, a tropical hardwood imported from South America. Cabin top is 3/4" Silverballi t&g with 1/4" Hydrotek meranti marine plywood with two layers of fiberglass over. All interior bulkheads are Hydrotek 3/4" plywood.

Pilot House: All Sapele hardwood with Port Orford Cedar T&G ceiling and 1/4" Hydrotek plywood with fiberglass over.

Spars: Main mast is laminated solid Douglas Fir. Foremast and booms are solid mahogany. Both spars were pulled and refinished in 2021. Bowsprit is original, Sao wood.

Tankage:
- One 130 gallon fuel tank, 12 Gauge 316 SS purge welded
- Two 35 gallon Polyethylene water tanks
- TORRID® 17 Gallon hot water tank
- One 50 gallon Polyethylene holding tank
- Whale Guzzler greywater pump w/ solid state control (new 2022)
- Spectra Watermaker, needs service and new membrane, Clark pump is new 2021

Waterline Boats / Boatshed does not independently verify capacities and measures, which are reported from seller-provided information and/or literature.

Along with the extensive renovation of the vessel structure the interior was re-designed and fabricated out of exotic woods and top quality equipment while maintaining an authentic look in layout and equipment type chosen for installation.

Enter the vessel interior from the cockpit into the pilothouse salon. There is an array of instrumentation amidships to monitor systems and for communication. Good visibility is provided with wrap around windows. The pilothouse does not have a helm station or steering. There is settee sleeping for one. The mainmast is forward in this space and companionway stairs lead down and forward to the main cabin.

The L-shaped galley is to starboard as you enter the cabin. It features a Dickinson Adriatic diesel stove with a hot water coil (new 2013) and a 2 burner propane cast iron cook top positioned on the stove (new 2013). This permits a choice in the use of the diesel cook stove or the separate propane burners for meal preparation. Twin Isotherm stack-able built in refrigerator-freezers provide for cold storage. A deep double, hammered copper sink is forward in the galley. To port is a private cabin with a double berth.

To port is an L-shaped settee with a dining table. This settee would provide an additional berth possibility. To starboard is an opposite seat and an outboard pilot berth behind it. At the forward end of the seat is a cast iron Little Cod solid fuel stove (new 2013) in a proper enclosure. There is ample storage in hanging lockers and drawers throughout the main salon. Two overhead opening hatches provide light and ventilation along with new bronze portlights.

Forward to port is the marine toilet compartment. This features a Tecma 24v marine toilet (new 2023). A separate shower is set in a tiled tub enclosure.

Forward from here through a private entry is the forward cabin. This is traditionally laid out V-berth with sleeping for two. The anchor locker is forward and the foremast steps to the keel in this cabin.

- Dickinson Adriatic diesel stove (new 2013)
- 2 burner propane cast iron top on stove (new 2013)
- 2ea. Viking composite propane tanks with solenoid control in aft rail rack
- Little Cod solid fuel stove (new 2013)
- Engine supplied hydronic heater in forepeak cabin
- Marco Mate potable water pump (new 2022)
- TORRID® 17 gallon water heater and heat exchanger off the engine. This unit will also hydronically heat the vessel.

2 حارق غاز طباخ