Nautor Swan 42

Fourwinds II wind generator.
Shore power for 115v and 220v with Marine Flyback Fast Charger.
50 foot 30 amp shore power cable.
PUR Power Survivor 35 12 volt watermaker.
Two 6 volt 350 amp house batteries, one 12 volt engine start battery (recent).

The Hood Symmetrical Spinnaker uses an ATN sleeve for storage and deployment. It is a beautiful custom design.

The main is furled into the mast using a Reckman/Nautor Main Sail electro-hydrualic furling.

Genoa and stay sail on Reckman roller furling systems.

Standing rigging replaced circa 2000 using Norseman fittings.

The roller furling main, Genoa 135 and Staysail by Carol Hasse Sailmakers of Port Townsend (new in bag 2004); red storm main and stay sails by Carlson Sails, Denmark, both in good condition. The Hood Symmetrical spinnaker and spinnaker pole and rigging, including ATN deployment system (collar, sleeve, and activation line) virtually unused, custom design.

Navtec hydraulic boom vang and backstay tensioner: Dutchman boom brake.

It is important to note that the rigging on this boat is geared for safe and easy sailing by one or two people.

12 batterie volts, 3 batterie(s) chargé(s) par: moteur, éolienne, prise de quai

The Nautor Swan is legendary for highest quality fiberglass construction. In addition to the beautiful, high performance hull and deck, much of the interior including the bilges are molded, gelcoated, finished surfaces.

A fin keel and outstanding hull lines with a feathering propellor provide high performance and outstanding sea keeping ability making a successful open ocean cruiser and racer with trans-Atlantic and trans-Pacific race victories documented.

The hull is bottom coated using Interlux 2000 process involving 10 coats @ 20 mils (2007). Hull bottom painted using Petit Neptune. Topsides machine polished 2013.

The steering cockpit is aft with pedestal steering under a bimini shelter. Entrance to the cabin is forward just aft of the mast behind a dodger.

Decks are teak with the cabin top fairing smoothly into the foredeck for easy footing handling sails.

There is a USCG approved type 1 Raritan Lectra/san on board sewage treatment system newly installed and never used.

Entering the main cabin by ladder from the center deck area, the "L" shaped galley is to port with a three burner gas range and a double stainless sink forward. A fold up counter extension to center from the sink cabinet provides extra counter space as needed. Both pressure water and foot pumped water serve the sink.

The refrigerator/freezer is powered by the engine as well as 115v/220v shore power and 12v house batteries.

The main cabin features built in seating on both sides with a folding table. The seating areas make up as single berths.

In the bow compartment there are two single berths and storage under. The anchor chain passes through the bow cabin between the berths in a large diameter stainless steel tube to the anchor storage under the floor, for a low center of gravity.

The master cabin is aft with a double berth to starboard and a single berth to port. To starboard is the head with basin and manual toilet through a door from the aft cabin or the main cabin area.

To starboard of the entry ladder is a nav station with storage for charts as well as the radar, sounder, GPS and radios, including the Icom IC-M700 SSB.

The interior is finished in beautifully fitted varnished teak with teak and holly floor.

The engine is accessed behind a cover under the entry ladder as well as an access to the rear of the engine and gear through the master cabin. The dripless shaft seal is accessed through a floor hatch in the master cabin.

3 feux(s) gaz cuisinière